Product Description

Dress up your windshield with this quality, engineer grade vinyl decal.  
**This decal is CURVED to FIT the contour of you windshield for a perfect and stock fit!**

Choose from OUTLINE (pictured) or SOLID. 
Windshield wipers will NOT touch the decal if properly installed.

 This is an official GM Licensed Product.

General suggestions for the installation:

1. We recommend washing the entire car first.  Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt.   Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It's recommended to work in 50 ° F or warmer) temperatures.

3. Before peeling off the backing, check the positioning.

4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).

6. Try to let the adhesive set for 24 hours before washing the car again after decal application.

Product-specific recommendations:

Windshield Banner Decals

Wet Application:
(NOT recommended for Reflective.  Reflective material is to be installed DRY.   Wet is for NON Reflective only)

•  You'll need a spray bottle of water with a drop of dish-soap.

•  Generously spray the application area with the water.

•  The decal is sandwiched between the mask (clear cover) and the backing. Carefully peel way the backing and spray the back of the decal with the soap and water solution.

•  Hold the decal over the windshield/rocker panel (it helps to have two people here, one on each side of the car). Lay the decal on, then set it straight.

•  Once you are sure of it's position, squeegee the water out with a flat tool such as our application squeegee, a rubber squeegee or even a credit card will work. Squeegee from the center of the decal and push the water out of the edges.

•  Let the decal stay on the car for about 45 minutes to an hour before peeling off the masking. If the decal peels up with the masking, let it sit longer to let the water dry and the decal stick to the surface.

Dry Application:

•  Use the same steps above, but without water. Be sure to squeegee out any air bubbles and be sure of exact placement before applying the decal to the surface.

•  It helps to tape the decal in place, remove half the decal from the backing and apply half at a time.

•  After applying, let the decal sit for about 10-15 minutes before removing the masking.