Product Description

This decal was designed to fit perfectly over the existing Arrowhead. When we say perfectly, we mean PERFECTLY. None fit better and we guarantee it!

Please note: This is not an arrowhead replacement decal, this is an overlay.  Click HERE to purchase a replacement.

Reflec-Dome Option: See first-hand what everyone has been raving about and try our new Reflec-Dome option! This is a durable polyurthane resin applied to the top of the arrowhead decal. Add a unique look for a low cost!

- This is ONLY available if you select a border color.

NOTE: To order a full set of decals for the arrowhead like pictured above, you must select both a Color and Border. Make sure to carefully pick your colors appropriately so that you get exactly what you want.

To make your arrowhead look similar to the picture just above, choose:
Color- Reflective Red
Border- Reflective Light Silver.

If you order only "Color" and not a border, it will look like the reflective red section of the picture. The decal without a border only covers the red section on the factory Arrowhead.

If you are choosing two-tone, do not select the same color.

General suggestions for the installation:

1. We recommend washing the entire car first.  Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt.   Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It's recommended to work in 50 ° F or warmer) temperatures.

3. Before peeling off the backing, check the positioning.

4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).

6. Try to let the adhesive set for 24 hours before washing the car again after decal application.

Product-specific recommendations:

Arrowhead Overlay (NO Reflec-Dome option)

• The decal is sandwiched between the mask (clear cover) and the backing. Carefully peel away the backing. Line

the decal up over the arrowhead by looking through the mask. Be careful not to let the decal touch the badge

until you are ready to apply.

• The “background” version (solid) should overlap each side of the arrowhead slightly to cover more completely.

• The “foreground” version (cut out) is designed to cover the stock, red center only.

• If you use both together, install the “background” first. Then line up the “foreground” and apply. Because there

are no reference points on the second step, you'll have to “eye it”.

Domed Arrowhead Overlay(WITH Reflec-Dome)

•  Carefully peel away the backing.

•  Line the decal up over the arrowhead. Be careful not to let the decal touch the badge until you are ready to apply.

•  Once you are certain on where you'd like to apply it, press lightly around the edges and center of the Domed arrowhead, but be careful not to put too much pressure on it.