These decals are computer-cut and high quality, designed to fit perfectly over the existing badges on the doors and trunk lid. 
- Sold in a set of THREE.
- Leave the quantity set at 1 to receive decals to cover both door badges and the trunk badge.
Product Installation Instructions
General suggestions for the installation:
1. We recommend washing the entire car first. Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt. Q-Tips help with cleaning out crevices. Be sure there is no alcohol or water on the badge during the decal application.
2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application. It's recommended to work in 50 ° F or warmer) temperatures.
3. Before peeling off the backing, check the positioning.
4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.
5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).
6. Try to let the adhesive set for 24 hours before washing the car again after decal application.
Product-specific recommendations:
ྜྷ-‘03 SE & GT Badge Overlay / Trunklid Overlay
• The decal is provided in three sections for each badge to ease installation. The decal is sandwiched between the mask (clear cover) and the backing. Carefully peel away the backing. Line the decal up over the badge by looking through the mask. Be careful not to let the decal touch the badge until you are ready to apply.
Vehicle-Specific Decals & Shirts 
