Product Description

Replica decal sized to the exact dimensions of the "DAYTONA" and "500" on the rear bumper of the Pontiac Grand Prix Daytona Pace Car.  

  Dark Navy Blue will most closely match the decal that comes on these vehicles and is the default color selection below.  This color is NOT reflective.  You may choose from any of our listed colors if you don't wish to stay with the blue.

• This is a replacement decal, not an overlay.  The old decals must be removed before applying.
• Two parts are included with this decal: "DAYTONA" and "500".  The "500" will be separate, so it is important to take measurements of location before removing your old decal.

ReflectiveConcepts.com

Here are some general suggestions for the installation. 

1.    We recommend washing the entire car first.  Then cleaning the application areas (badges, indents, etc.) with rubbing alcohol several times to remove any other oil or dirt.  Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2.    For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It’s recommended to work in 50° F (or better) temperatures.

3.    Before peeling off the backing, check the positioning. 

4.    When applying, work from top to bottom or left to right, holding the unapplied material away from the surface.  Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5.    After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks.  It’s critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit 15 minutes before removing the mask (if it has one).

6.    Try to let the adhesive set for 24 hours before washing the car again.

’97-’03 DAYTONA 500 Rear Letting ·      Be sure to MEASURE placement of the old decals before removing them. ·      Remove the old decals.  Using a heat gone will help soften them up.  Use a product like “Goo Gone” to remove the extra adhesive. ·      It is important to be sure all of the old adhesive is gone before applying the new decals. ·      It helps to have two people- one holding each end of the “DAYTONA” decal.  ·      Peel the white backing away, but holding the clear masking.  Be sure the decal sticks to the clear masking. ·      Hold the decal up over your measurement marks and press firmly to apply once you are sure of it’s position. ·      Rub it down with a flat object such as a credit card.   ·      Wait about 5-10 minutes before removing the clear masking. ·      Press once more to be sure the decals are firmly stuck. ·      Apply the “500” in the same fashion.

Here are some product specific recommendations: