Product Description

This decal was designed to REPLACE the factory Arrowhead. When you remove the factory arrowhead, there is a gap in the bumper.  This domed decal will fit in there perfectly for a unique, clean look!     This will work well with aftermarket bumpers that don't have a cut-out for the Arrowhead.

 Please note: This is a replacement decal, this is not an overlay and the stock arrowhead must be REMOVED before applying.

 
Reflec-Dome Option is included!: This is a durable polyurthane resin applied to the top of the arrowhead decal. 
Please note- these are custom-made to order.  There is a 6-day lead-time to allow for the curing of the Reflec-Dome before these are shipped.  

NOTE: To order a full set of decals for the arrowhead like pictured above, you must select both a Color and Border. Make sure to carefully pick your colors appropriately so that you get exactly what you want.

To make your arrowhead look similar to the picture just above, choose:
Color- Reflective Dark Blue
Border- Reflective Light Silver.

If you order only "Color" and not a border, it will be just one solid color.  The color of the car will show through the "star" in the center of the arrowhead as this will be cut out.

Do not select the same color for both "Color" and "Border".

General suggestions for the installation:

1. We recommend washing the entire car first.  Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt.   Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It's recommended to work in 50 ° F or warmer) temperatures.

3. Before peeling off the backing, check the positioning.

4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).

6. Try to let the adhesive set for 24 hours before washing the car again after decal application.

Product-specific recommendations:

‘97-༿ Grand Prix ™ Arrowhead REPLACEMENT Decal

•  Remove the stock arrowhead. Clean all the glue and dirt. Use a Q-Tip in the corners to be sure it's absolutely free of debris. Goo-Gone works great to get rid of left-over glue, but be sure to clean the area very well after you use with with rubbing alcohol.

When you are ready to apply-

•  Carefully peel away the backing.

•  Line the decal up over the arrowhead opening or any other area you'd like to apply. Be careful not to let the decal touch the surface until you are ready to apply.

•  Once you are certain on where you'd like to apply it, press lightly in the center of the Domed arrowhead working your way to the edges, but be careful not to put too much pressure on it. Press the top left & right corners and bottom point.