Product Description

Brighten up the emblem with our reflective colors or blacken it out with a dark color or carbon fiber. 

 This is and official GM Licensed decal designed to over lay the existing "IMPALA"™ emblem on the trunk lid of the 2006, 2007, 2008, 2009, 2010 and 2011  Chevrolet Impala™.  Brushed aluminum adds a unique touch to the chrome emblem.  Available in over 30 colors with a lifetime warranty.

Vehicle Application:
2006-2011 Chevrolet Impala SS

General suggestions for the installation:

1. We recommend washing the entire car first.  Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt.   Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It's recommended to work in 50 ° F or warmer) temperatures.

3. Before peeling off the backing, check the positioning.

4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).

6. Try to let the adhesive set for 24 hours before washing the car again after decal application.

Product-specific recommendations:

IMPALA ™ Trunk Badge Overlay

•  The decal is sandwiched between a white backing and clear masking. Because the lettering on the car may have shifted, it may be easiest to cut each letter off and apply it separately.

•  Hold the decal over the badge, looking through the mask to line it up. Be careful not to let the decal touch the badge until you are ready to apply.

•  Use the bottom horizontal lines and bottom corners of the badge to line the decal up. Once you are sure of it's position, rub the decal from the bottom, to the middle, then to the top.

•  Wait about 15 minutes before removing the mask to ensure the decal is stuck to the badge.