Product Description

Brighten up the Bowtie emblem with our reflective colors or blacken it out with a dark color or carbon fiber.  

 This is and official GM Licensed decal designed to over lay the existing Bowtie emblem on the rear lift gate of the Chevrolet TrailBlazer™.  Available in over 30 colors with a lifetime warranty.

Note:
This decal covers the front face of the emblem only.  The gold beveled edge and chrome trim will still show.

• A quantity of 1 is for one bowtie overlay decal for the rear emblem.

Vehicle Application:
Chevrolet TrailBlazer

General suggestions for the installation:

1. We recommend washing the entire car first.  Next, clean the application areas (badges, indents, etc…) with rubbing alcohol several times to remove any other oil or dirt.   Q-Tips help with cleaning out crevices.  Be sure there is no alcohol or water on the badge during the decal application.

2. For best results, work in a relatively warm, dry area and allow the working surface to change to the room temperature before application.  It's recommended to work in 50 ° F or warmer) temperatures.

3. Before peeling off the backing, check the positioning.

4. When applying, work from top to bottom or left to right, holding the unapplied material away from the surface. Most colors (except Black and Lemon Yellow) will stretch a bit if absolutely necessary.

5. After Application, be sure to press the labels down firmly to ensure no air bubbles get trapped and to make sure the adhesive sticks. It's critical that you rub down the whole decal firmly to activate the adhesive and let the decal sit for at least 15 minutes before removing the mask (if it has one).

6. Try to let the adhesive set for 24 hours before washing the car again after decal application.

Product-specific recommendations:

Chevrolet Bowtie Overlay ™

This is a challenging decal to apply, so please take your time!

•  The decal is sandwiched between the mask (clear cover) and the backing. Keep the arrow pointing UP.

•  Carefully peel away the backing. Line the decal up over the emblem by looking through the mask. Be careful not to let the decal touch the surface until you are ready to apply.

•  Run your finger down the center crease of the bowtie while holding either side with your other hand. Try not to let the left-most and right-most sections of the decal touch the emblem quite yet.

•  CAREFULLY start working the decal to one side by pressing firmly, being sure all air bubbles are being removed. Try not to crease the decal when you're adhering it.

•  You cannot lift up on the decal once it's down, otherwise, it will distort the vinyl and color of it, so apply slowly and carefully.

•  If you do get air bubbles, press firmly to try to remove, or you may pop them with a small pin and press to work them out.