Vinyl decal designed and sized to fit on the front face of the factory front and/or rear bowtie emblems. The Precut Overlays stick onto the front face of the emblem, leaving the gold beveled edges exposed. The Wraps will wrap around the entire gold portion. The factory gold section of the emblem must still be in place in order to use these decals.
- A quantity of one is for 1 Front, 1 Rear or one of each (depending on Kit Selection above) Bowtie Overlay decal.
- Installation instructions included.
Due to the curvature of the factory emblem, a portion of the gold beveled edge will remain exposed!
A precut overlay cannot bend over the beveled edge of the emblem. These are meant to be peel and stick with no trimming, no heating and no stretching, so they only cover the front face of the emblem. Please be sure to review the product photos carefully.
This is an over-sized sheet of material that will cover all of the gold. You must use heat to then stretch it around the beveled edges and trim-to-fit. A heat gun or high powered hair dryer will be a required tool for this installation to get the vinyl to stretch and wrap.
Application: 2006-2009 Chevrolet TrailBlazer